Leadwell t6 smy barfeeder programing

[kenwood2]

Hello all.

I'm currently trying to program the new lathe (leadwell t6 smy). Its running fanuc 18i-tb
The problem i have is i cannot make the barfeeder working. (barfeeder is Fedek dh 65L s2).
In the attached pictures you can see what g code im runing.
The program start and all its fine until the subprogram /2 M98 p8000. The lathe give me error 004 addres not found but the subprogram is there?

https://drive.google.com/file/d/1v-S...ew?usp=sharing
https://drive.google.com/file/d/1EFx...ew?usp=sharing
https://drive.google.com/file/d/1kJB...ew?usp=sharing
https://drive.google.com/file/d/1tmr...ew?usp=sharing
https://drive.google.com/file/d/136H...ew?usp=sharing
https://drive.google.com/file/d/15uz...ew?usp=sharing

Any help will be nice

Similar Threads:

• Barfeeder
• Need Help!- LNS barfeeder with M32B
• 300 barfeeder problem
• lipe barfeeder

[kenwood2]

Hello This is the program for barfeeder on t6 smy.

G40 G80 G54 G99
G30 U0 W0
M31
M33
T0404
G0 X0 Z0
M10
G4 X1.
M26
G4 X2.
M0
/M98 P78
M27
M11
M34
G4 X3.
G0 Z2.
G30 U0 W0

[the_gentlegiant]

Is the program listed above the O8000 program?

If so the program above is asking for another subroutine O78. (/M98P78) Although it has a block skip in front of it. Is that Subroutine missing on the control? What happens if you run with Block Skip on?