...looking at your dialog for first thing I see is missing decimal points possible. did you try 1.0000 instead of just 1 ?
Is anyone here familiar with Intuwiz G-Code Generator?
I bought this software and can NOT Get it to work properly on a simple 2 inch Circle by .500 deep.
Trying to set it up with a .25 tool, cutting .025 per pass on Aluminum.
Will try to post picture of this interface,
Thank You for looking,
cubs
Similar Threads:
...looking at your dialog for first thing I see is missing decimal points possible. did you try 1.0000 instead of just 1 ?
No I did not use decimal points,, Of Course this was just a copy of program I am trying to use,
cubs