- ProStar PRS4 with FlashCut controller Dual Y Stepper issue
-
Registered
ProStar PRS4 with FlashCut controller Dual Y Stepper issue
I'm trying to assist a friend who is running a ProStar PRS4 with a FlashCut controller running v7.0.6.26. It has a dual Y configuration with MP-3403 steppers. When jogging the Y axis, the Y steppers are moving at different rates, causing the gantry to bind. It is configured as shown in the manual. The Y motors are defined, and use sub axis 1 & 2. Any idea what could cause the different speeds?
Thanks much
Attachment 466155
-
- ProStar PRS4 with FlashCut controller Dual Y Stepper issue
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules