New Flashcut Install

[ranchak]

Hi Guys, I just made the leap over here to Flashcut. I have been having problems with Mach and finally had enough. I just installed my Flashcut, but I don't have any motor movement. I am sure that I did not set something correctly. I am using a PMDX-122 BOB, I have an adapter that the hus at Flashcut wired up for me, Gecko 203Vs and stepper motors. Anybody have any thoughts? Thanks in advance.

Similar Threads:

• Un-install & re-install changes Mach3
• Is Flashcut still around?
• How do you like FlashCut?
• Newbie- Flashcut CNC?

[woodman08]

surprised you went to flashcut ,as flashcut is not widely used in cnc plasma.
we use flashcut and wish we didn't .As far as i can see torchmate is the only user of flashcut.
We really could use a check on our settings

[powerr]

On the pmdx board do you have jumper jp3 set to non e-stop fault?

[powerr]

check the pmdx board jumper jp3. is it set to non e-stop fault. if that is not it try with out the breakout board. i am not for sure what else the pmdx has for interfacing. I am not a big fan of breakout boards.

[ranchak]

That was the problem, I am using Flashcut for a CNC mill. So far I like it, but it's still early in the game. One thing I have to say is that Ron at Flashcut has been very helpful and has spent as much time as necessary with me to correct any issues that I had.

[powerr]

yes they Flashcut will do what they can to help you out. glad it was a simple fix.