appraoching problem

Results 1 to 4 of 4

Thread: appraoching problem

  1. #1
    Registered Mr_Mill's Avatar
    Join Date
    Mar 2009
    Location
    Albersdorf
    Posts
    8
    Downloads
    0
    Uploads
    0

    Default

    Dear colleagues

    I have the following problem with my controller (FIDIA M20) when approaching the basic rotation over two circles:
    "ICY000 ERROR: Radius max lower than Radius min."

    Does anybody has had that problem before and knows what to do?
    I can’t select the error message and press F1 as "ICY000" can not be found.

    Thank you



  2. #2

    Join Date
    Oct 2007
    Location
    Frankfurt
    Posts
    43
    Downloads
    0
    Uploads
    0

    Default

    Hello
    Check path C:FidiaWScca.dat.; in the CCA.dat you will find the minimum information.
    For example:
    5 Origin
    10mm C1x
    10mm C1y
    100mm C2x
    100mm C2y
    3000mm Maximum Radius
    10mm Minimum Radius
    4 Number of points for the circle
    20.mm Maximum error for circles

    Maybe you need to make some changes there, nothing bad can happen1
    You can also post your own values then we can have a look at them...



  3. #3
    Registered Mr_Mill's Avatar
    Join Date
    Mar 2009
    Location
    Albersdorf
    Posts
    8
    Downloads
    0
    Uploads
    0

    Default

    Hello
    Thank you for your answer but unfortunately that wasn’t the problem.



  4. #4

    Join Date
    Oct 2007
    Location
    Frankfurt
    Posts
    43
    Downloads
    0
    Uploads
    0

    Default

    Hello
    I just thought about something else... have a look in the service under MAINT PROBE if the radius is entered there. If not then that means, that the sensing device is not calibrated. Then the error message is wring again...
    ->Carry out Cycle PROBE SETUP (calibrate device). And try again afterwards.
    You should calibrate every 4 weeks with a Fidia anyway...

    Good luck!



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

appraoching problem

appraoching problem