3D zero contour

Results 1 to 2 of 2

Thread: 3D zero contour

  1. #1
    Registered rapido's Avatar
    Join Date
    Dec 2007
    Location
    Mutlangen
    Posts
    6
    Downloads
    0
    Uploads
    0

    Default

    Hope you can help?
    We get 3d outline contours from our programming department.
    When I load them into the isograph then calculate the tool paths and start the program then the machine jerks weirdly.
    What could be the problem?



  2. #2

    Join Date
    Oct 2007
    Location
    Frankfurt
    Posts
    43
    Downloads
    0
    Uploads
    0

    Default

    Hello,

    Try the following: run with an offset the outline as a zero contour as an Nc program in the W-axis (CQA WP +50.). Not over the Isograph but over the CNC.
    Meaning with EXCECUTE START PROGRAM. If the outline runs without jerking then the problem is connected with Isograph. In that case you should demand a new software at Fidia- then it’s a software error...

    You can also try another alternative: Change the Look Ahead parameter- but there are more details needed!


    Do you have a Fidia machine or just a Fidia controller with other equipment manufacturers.

    Have a look then I can tell you the necessary instructions .............

    Oh yeah software version is also helpful

    CNC



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

3D zero contour

3D zero contour

3D zero contour