- 5 axial circular pocket
-
Registered
Hello guys!
I had mill a pocket that was pivoted in the a-axes at 60 degrees.
I set the a-axis at 60 degrees, equated the centre point to zero at x y z, programmed 5 axial high-speed cycle.
The program works, but covering in the w axis isn’t axially parallel.
Can anybody help?
-
-
Registered
Hello Rapido!
You have to write RX60.RZ0.G21 in isograph.
Then call the high-speed cycle and program.
Then the boring has to be 60° pivoted in the simulation of isograph.
(rotation values always as head stands C is Z, a is X)
- 5 axial circular pocket
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules