5 axial circular pocket

[rapido]

Hello guys!

I had mill a pocket that was pivoted in the a-axes at 60 degrees.
I set the a-axis at 60 degrees, equated the centre point to zero at x y z, programmed 5 axial high-speed cycle.
The program works, but covering in the w axis isn’t axially parallel.

Can anybody help?

[Fidia-c20]

Hello Rapido!

You have to write RX60.RZ0.G21 in isograph.

Then call the high-speed cycle and program.

Then the boring has to be 60° pivoted in the simulation of isograph.

(rotation values always as head stands C is Z, a is X)