Want to know more ?
http://www.cnczone.com/forums/showth...ighlight=servo
A servo is a motor that can run just as effectivly in both clockwise and anticlockwise direction, it has an encoder attached to track its movement.
With a controller card the servo can be driven to a position and hold that position.
Many CNC machines use servos to drive the working tool into a desired position
Similar Threads:
- Servo Dynamics, West Amp, Servo driver, Anilam, 1400 relay board 901-175
- Need Help!- MR-J40A servo amplifyer - Need help to change Servo loop type
- couple of sets of Indramat Servo Controller+Mains filter+Servo Motor 9Nm, 4500rpm
- JAPAN SERVO ROTARY TABLE MECHANISM CNC THK IKO NSK SERVO STEPPER
- Galil Motion Controller, with NEMA 23 Servo Motors, Servo Drive, Encoders, Etc.
Last edited by ynneb; 08-17-2004 at 02:50 AM.
Being outside the square !!!
Want to know more ?
http://www.cnczone.com/forums/showth...ighlight=servo