Takisawa-Tc-1-Fanuc-Ot( clamp-unclamp-M68-M69)

[Hamiid]

Hello good time
I just joined this forum, I had a question, I'm asking for help, my machine is Takisawa with Fanuk Ot controller, I want to write a program for Bar puller, the code opens and closes the collet (M68---M69), when it enters the program, the command to open the M68 collet works again It does, but after the command to close the collet M69, the axes no longer move, and the program stops there.
My Email:hamiidkabiir@gmail.com

Similar Threads:

• Speeding up M68 & M69 Lathe Chuck Clamp & Unclamp
• Clamp / Unclamp
• hwacheon hi eco 21 1994 fanuc ot control chuck clamp unclamp problem
• Clamp and unclamp
• Mori ZL200SMC M68 and M69 command issue - Machine Down