Daer all.
I'm used Operator's Panel( A16B-1310-0380) board on Fanuc OMC system. I'm can run Test run OK, but I can not make it available inside PMC( all F292.0 - F299.7 is allways= 0 when I depress any button), even I was set Operator Panel= 1 in PMC System Parameter. Please guide me to fix this problem, many thanks.
Nam.
Dear all.
This problem was solved when I connecct both M1A and M2A wire( maybe the problem is the NC8 signal, locachted in MB2.50 pin).
Thanks for your attention. Please close this topic.
Nam.