Takamaz X-15 Hi-Server PLC Error list
Hello everyone,
we have purchased an old Takamaz X-15 turn in an auction. As you all may have already noticed, we don't have much information about it. We only have a basic operator manual, mostly referred to the Fanuc 21 controller.
In the front panel of the machine there is an small 7-segment display, wich displays PLC errors of wich we don't have any information. Nowadays the only one we could figure out was the 01 error, wich is low air pressure. We ignore the meaning of the rest of them.
The machine worked fine for a couple of days. But at some certain point, when we try to start a cycle, the message 38 appears briefly and then the message 17 remains.
Does anyone have the errors list for this machine?
Attached is a photo of the front panel.
Regards!
Similar Threads:
Reply with Quote
