Doosan/FANUC 0i-M AICC

[mtparker18]

Hi all,

I'm not sure if this is the best forum, or if I should have posted this in the Doosan specific forum, butttttt.

I have a brand new Doosan DNM4500 with the 0i-M Control.
I'm currently working on implementing the AICC settings into my programs. When I add a G05.1 Q 1 Rx value, my AICC on the control always shows AICC 2. Does anyone know if this is correct (aka always shows this), or if something isn't positing correctly?

I'm sure I'll have to call Doosan and ask, but didn't know if this is a common thing or if someone has any suggestions before I go down the rabbit hole of my distributor.

Thanks in advance.

Similar Threads:

• Fanuc 0i-MD - Faceted with AICC 2
• AICC vs. AI APC
• Fanuc 21i-mb AICC settings
• Aicc/hpcc Vs Hsm (non Fanuc)
• AICC HPCC Help

[Dale123]

This is correct . It always shows AICC 2 whatever Precision Level is set with the R Value.