FANUC 10T TURRET SPEED SLOW DOWN?

[tano]

Hi guys
Can somehow slow down the rotation speed of my turret in parameters?

Similar Threads:

• Need Help!- MACH3 "Home" speed very slow until STOP is pressed, then normal speed restored
• Fanuc Oi-TF vs. 31I-B block processing time / speed Is Oi-TF really this slow?
• Problem- Fanuc 10T parameter setting for turret direction??
• Fanuc 10T Turret Rotation Problem
• Need Help!- 0344 turret parameter setting error (fanuc control 10T)

[zavateandu]

if the turret is controlled by a servo motor can be done but we need more info about the type of Fanuc and info about the servo drive
If the turret is controlled by a hidraulic motor you need to adjust the speed from the flow of the oil.

[tano]

The Fanuc is FS10TF
The turret is mechanical powered by small motor 0.4kw

if the turret is controlled by a servo motor can be done but we need more info about the type of Fanuc and info about the servo drive
If the turret is controlled by a hidraulic motor you need to adjust the speed from the flow of the oil.

[tano]

Hi
I solved the problem. Install frequent regulator and change the speed from 50Hz to 30Hz. Now the turret work slower but without any noise.

The Fanuc is FS10TF
The turret is mechanical powered by small motor 0.4kw

[cncmakers001]

Hi
I solved the problem. Install frequent regulator and change the speed from 50Hz to 30Hz. Now the turret work slower but without any noise.

That's clever.