Need Help! dnc for leadwell mcv 1000 ap


Results 1 to 2 of 2

Thread: dnc for leadwell mcv 1000 ap

  1. #1
    Member esmaeelsolymani's Avatar
    Join Date
    Oct 2021
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default dnc for leadwell mcv 1000 ap

    Hello friends
    I have a leadwell mcv 1000ap device with fanuc o-m model f
    Produced in 1990
    In this device, the parameters can be transferred to the device and computer
    The G-code program can also be transferred to the device memory
    But it is not possible to send the program from dnc software such as cimco and run it by the device
    Thank you for your help

    Similar Threads:
    Attached Thumbnails Attached Thumbnails dnc for leadwell mcv 1000 ap-1-jpg   dnc for leadwell mcv 1000 ap-2-jpg  


  2. #2

    Default Re: dnc for leadwell mcv 1000 ap

    Do you see a "Tape" or "DNC" mode selection on the operators panel. The old membrane style panels were nearly impossible to re-label so it is possible an un-labeled button will select DNC/Tape mode.
    You can check the ladder for G127.5. This bit on (1) in conjunction with Auto mode places the control into DNC/Tape mode.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

dnc for leadwell mcv 1000 ap

dnc for leadwell mcv 1000 ap

dnc for leadwell mcv 1000 ap