Need Help! FANUC MDI mode not working (O-MD control)


Results 1 to 7 of 7

Thread: FANUC MDI mode not working (O-MD control)

  1. #1

    Default FANUC MDI mode not working (O-MD control)

    Hello everyone,

    We have a 1000 YANG with an O-MD Fanuc control, few months ago we lost all the parameters, so we had to upload them manually and get it to work again, and since then we kept solving all the issues we were having,

    For example few days ago we couldn't even upload a program, but now we're facing another issue,

    When we try to input anything with the MDI mode, nothing is happening, we can't edit a program or even test the machine or put the tool offsets,

    Normally the display "program(MDI)" should be showing the name of the program "address" and ends with "%"(1st picture) , but it's not even showing any of that (2nd picture),

    is there a specific parameter I can modify please ?

    Similar Threads:
    Attached Thumbnails Attached Thumbnails FANUC MDI mode not working (O-MD control)-img_2273-jpg   FANUC MDI mode not working (O-MD control)-242072519_1031818587592613_4765090615097114476_n-jpg  


  2. #2
    Member bytor581's Avatar
    Join Date
    Aug 2021
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default Re: FANUC MDI mode not working (O-MD control)

    When the parameters were lost, did you check the battery's?



  3. #3

    Default Re: FANUC MDI mode not working (O-MD control)

    The parameters were deleted, they weren't lost because of the batteries



  4. #4
    Member
    Join Date
    Apr 2011
    Location
    USA
    Posts
    787
    Downloads
    0
    Uploads
    0

    Default Re: FANUC MDI mode not working (O-MD control)

    Did you put in the Diagnostic parameters too? Double check every parameter as it only takes one bit to have been missed to hose you over.



  5. #5

    Default Re: FANUC MDI mode not working (O-MD control)

    Yes I did , but some of them are just impossible to modify , when I try to put them , nothing seems to change ( just a few of them ) the ones from 300 to 600 right ? ( DIAGN)



  6. #6
    Member
    Join Date
    Apr 2011
    Location
    USA
    Posts
    787
    Downloads
    0
    Uploads
    0

    Default Re: FANUC MDI mode not working (O-MD control)

    Quote Originally Posted by AymenTajine View Post
    Yes I did , but some of them are just impossible to modify , when I try to put them , nothing seems to change ( just a few of them ) the ones from 300 to 600 right ? ( DIAGN)
    That because the ladder is writing to them. That should be OK.



  7. #7

    Default Re: FANUC MDI mode not working (O-MD control)

    So how am I supposed to put them when I can't modify them ?



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

FANUC MDI mode not working (O-MD control)

FANUC MDI mode not working (O-MD control)

FANUC MDI mode not working (O-MD control)