WIRE EDM G10 L2 Not working for workpiece setting

[wes862]

Looking through the Operator Manual, There is no call out for G10 L2 Work offset setting.
Does this work in Fanuc Wire EDM?
18i Controller.

Any guidance on how to set work offset via program in Fanuc wire?

Thanks

Similar Threads:

• Sodick AG600L Wire EDM - EDM wire rewinds to spool after cut at end of program.
• Problem- Mitsubishi wire edm water level dropping in working tank
• Need Help!- Setting workpiece zero with G10
• Need Help!- Wire EDM Stepper Motors Not Working
• Heat in the workpiece, wire edm