The problem with a sub for a Fanuc AC motor encoder is the encoder also has the commutation track on it which are a proprietary method that Fanuc uses.
Where are you located, I may have one, would have to check.
Hello! I have a bad encoder for a Fanuc 10T AC servo drive. The glass encoder disk is actually scratched and the print is worn off from rubbing on the photocells. It is a Type A860-0345-T001. I'm having a lot of trouble finding one anywhere. My question is; are there any compatible encoders that have the same disk/internals that I could look for to use for an organ donor? Thanks!
Similar Threads:
The problem with a sub for a Fanuc AC motor encoder is the encoder also has the commutation track on it which are a proprietary method that Fanuc uses.
Where are you located, I may have one, would have to check.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
I'm located in southeast PA
Hey Al, did you happen to get a chance to see if you had the encoder?
No sorry I meant to get back, I don't have that model.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
What kind of machine. Your encoder is high speed and high resolution encoder. This encoder is rare.
Sent from my iPhone using Tapatalk
You must buy same encoder because your motor have hollow shaft. Screw move through motor.
Sent from my iPhone using Tapatalk