Fanuc 18T PMC Program EDIT

[m_ghaff2000]

I have Ladder III software . I cannot edit PMC program no communication between PC and control? ( Fanuc 18t Year 2000)
Which setting shouhd be set on machine?
Please help me.
Thanks

Similar Threads:

• Need Help!- VMC 15 XT won't edit program
• cant edit program in fanuc ot
• Newbie- Fanuc Series 180i-MB : Program is Now Write Protected...Cannot Edit!
• Edit program while DNC-ing it from memory card. Is it possible? (fanuc 18i mill)

[agering]

You need to read the program Ladder from chip EPROM memory which is found on PMC .Hereon you need to convert the file EPROM copy to the format #EX which understands old LADDER II package. If you send me EPROM copy file I can help you.

[memoryman]

A control from year 2000 would be a iA, so no eprom involved.
Please provide system information (exact control, PMC version).

[m_ghaff2000]

Thanks
when our machine were installed a man from machine maker connected to control and checked and edit the PMC control online by PC and Ladder software.
But I can not connect there are some setting on control ? I dont know!

[memoryman]

Please provide system information (exact control, PMC version).

[tuanpq]

I have Ladder III software . I cannot edit PMC program no communication between PC and control? ( Fanuc 18t Year 2000)
Which setting shouhd be set on machine?
Please help me.
Thanks

Fanuc 18T use EPROM to store PMC ladder, so you don't edit it by Ladder III software. you can read it by Ladder III sofware.

[m_ghaff2000]

Thanks
Please check our system

[m_ghaff2000]

Thanks
Please see the new post.

[junlu691]

?????LadderIII??????????????????LadderIII???