Amada aries 222 Fanuc/Amadan O3P controller


Results 1 to 1 of 1

Thread: Amada aries 222 Fanuc/Amadan O3P controller

  1. #1
    Member
    Join Date
    May 2011
    Location
    ausralia
    Posts
    22
    Downloads
    0
    Uploads
    0

    Default Amada aries 222 Fanuc/Amadan O3P controller

    Hi everyone,

    I have an Amada Aries 222 with an Amadan O3P controller. The a few years in the middle of a job it shut itself down, didn't throw an alarm or anything, just powered down the controller.
    Now when i power up the machine it just lights up every button on the controller panel and has a cursor blinking on the screen and that's as far as it gets. Just wondering if anyone has had this problem or might know where to start looking. I have checked all the boards for component failure and cant see anything obvious. Would greatly appreciate any assistance.

    here is the original thread i posted for some extra info, https://www.cnczone.com/forums/dnc-p...ontroller.html
    If anyone has any suggestions as to what you think it might be i would greatly appreciate any ideas....

    regards,

    Peter

    Similar Threads:


  2. #2
    Motslav's Avatar
    Join Date
    Jun 2024
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Re: Amada aries 222 Fanuc/Amadan O3P controller

    Hi, Peter !

    Did you find the solution of the problem ? I have the same problem and also machine every time turns off after power on



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Amada aries 222 Fanuc/Amadan O3P controller

Amada aries 222 Fanuc/Amadan O3P controller