Need Help! Cannot change parameter 340/341 - Pega 357 04P-C


Results 1 to 3 of 3

Thread: Cannot change parameter 340/341 - Pega 357 04P-C

  1. #1
    Member WSMAU's Avatar
    Join Date
    Sep 2020
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default Cannot change parameter 340/341 - Pega 357 04P-C

    Hi all
    Had an issue with an accidental memory wipe (DO NOT hold zero/delete whilst powering on! in a bid to clear alarm "memory clear required")
    Thankfully, had the sense to create a backup tape file (machine.t and pc.t) so do have access to all the parameters. I'm able to set PWE to 1 and change almost every parameter manually, however the 2 that set the input and output device will NOT change. Tried from the SETUP page with not change and also from parameters 340 and 341 (which I read on this forum).
    Is there an access level I need to unlock??

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Cannot change parameter 340/341 - Pega 357 04P-C-pega-setup-screen-jpg  


  2. #2
    Member WSMAU's Avatar
    Join Date
    Sep 2020
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default Re: Cannot change parameter 340/341 - Pega 357 04P-C

    Just to add, I'm using a program called Code Shark. Although the backup was done using Code Shark, and I can open the .T file, nothing appears on the screen. If I open it in notepad, all the P and N data is there.
    What do you guys use to transfer the .T file back to the 04P-C ?



  3. #3
    Member WSMAU's Avatar
    Join Date
    Sep 2020
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default Re: Cannot change parameter 340/341 - Pega 357 04P-C

    Slow progress - I entered parameters N000 through N0010 as well as N0300 through N0312
    This somehow allowed me to access and change N0340 (INPUT) and N0341) OUTPUT.
    Once I did this, set the machine into READ mode (SETUP, > button, then P-9999 READ)
    With the READ flashing, I sent the backup file and all appeared to have gone in - there were 7 blocks not sent.
    I not get alarms:

    240 +C OT
    417 X SERVO DGTL PARAMETER
    427 Y SERVO DGTL PARAMETER
    447 C SERVO DGTL PARAMETER

    Have double checked 8100-8124 (X-axis), 82xx (Y-axis) and 83xx (Z-axis)
    I assume 84xx is for the C axis but not sure

    Any ideas?

    Attached Thumbnails Attached Thumbnails Cannot change parameter 340/341 - Pega 357 04P-C-pega-alm-screen-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Cannot change parameter 340/341 - Pega 357 04P-C

Cannot change parameter 340/341 - Pega 357 04P-C

Cannot change parameter 340/341 - Pega 357 04P-C