Hi
if you can make a small video and send it to me, it is better to understand me and accordingly I can explain it to you.
Regards
Deepak
Hello Sir, we have a Turret Punch Press Strippit 1250 MH machine which controller is GE Fanuc O-P Series . We have this problem that the controller is not booting.Please tell me solution.
Similar Threads:
Hi
if you can make a small video and send it to me, it is better to understand me and accordingly I can explain it to you.
Regards
Deepak
Do you have any procedure to boot the controller?
You may have a short somewhere. As the controller boots up and sends control power out to sensors and outputs, one shorted could draw down the power supply and shut the control back off. Seen it many times.