Hitachi Seiki with Micon 8 on a Fanuc 6 problems.

[jacof]

Good day and best for the year ahead.

Guys, i got a problem i hope some one out there can help with.

Mori Seiki VA-40 MILL with a FANUC 6 control and assisted by a MICON 8 driven ATC.,

Machine lost its MICON parameters due to battery failure.

Problem is i do not have a back up list for this machine . Found the timers for it but need the parameters for the EPROM settings under the 30/31 mode.

Does any body out there have a list of these parameters or hopefully a similar machine to get a copy of them?

Your help would be appreciated.
Thx Guys

Similar Threads:

• Need Help!- Micon 16 hitachi Seiki Secos II - ladder save
• Need Help!- Hitachi seiki PLC Micon 8 alarm
• Hitachi Seiki HG500 Fanuc 15M Micon 16 II
• Need Help!- Hitachi Seiki Micon 16-II
• Problem- hitachi seiki with Fanuc 6MB and Micon 16

[jdeere4250]

It's a hitachi seiki, not mori.

Is it a micon 8-1 0r 8-2?

Does the micon board have a ptcoda number or sqm8?

I have worked on a lot of hitachi may have what you need.

[jacof]

Hi jdeere4250

Sorry for the mori thing.

I think it is the Micon 8 Model II (SQM8). it only has 1 switch on the CPU Board(WRSW).

Your help will be appreciated.