robodrill I/O advice,

[robodrillman]

Hi,
I have a robdrill T10-A In my garage, still doing bits of jobs on it and I have ordered some manuals from fanuc uk but the delivery is 3 months away, I have no power to it yet as my energy supplier is coming to fit a 3 phase supply sometime in the next 6 months!!!!
I am wanting to fit a LED light bar for the work light and wire in a operator patrol light (red/ yellow/ green) 24vdc 3w, and also to make things more complicated! I have an indexer (HAAS 5c) that I need to find a spare M code to start the cycle on the indexer,
the I/O board number is A16B-1010-0482/01A
does anyone have any info or a picture of the outputs on this board or any bits of info that will help me get these jobs done properly,
any help appreciated,
Chris.

Similar Threads:

• New Fanuc Robodrill or 7000 hour robodrill with all the bells and 4th axis?
• Looking for used Robodrill or similar
• Robodrill HSM
• Robodrill HSM

[freakycnc]

Here's a T10 indexer connection...Robodrill T10.pdf

[robodrillman]

thanks, I give it a go when I get it hooked up,

[robodrillman]

hi freakycnc,
thanks for the info it worked a treat,
chris.