How to go about getting om-c ladder edited for dnc function

[Chopdr230]

Hi i have a miyano tsv-35 and it dose not have tape or dnc modes , no switches on the control . I am able to see the ladder and searched for g127.5 and its not there . Is it possible to have it added ? who or where would do this ? i currently only have 48k memory and can only run small programs . I have found some info on upgrading the memory but if possible id like to be able to drip feed my machine . any info would be greatly appreciated . Thanks

Similar Threads:

• pls, what is causing this error : 9135 igf data can't be edited while selecting NC ..
• Newbie- CAD files can be edited in VCarve Pro but not in Cut2D. Valuable feature?
• x2 or Sherline *edited*
• How do I load an edited G code program

[the_gentlegiant]

I have a YCI Supermax with OMC. M50 and M51 turn DNC on and off. Not sure which is which. I think M51 on. If I find out different tomorrow at work I'll correct this. Can't promise this will work on your machine. You also need software to drip feed to your machine. dnc4u is what I use. Works great.

[Al_The_Man]

There is a few older posts on the subject e.g. https://www.cnczone.com/forums/fanuc...m-ladders.html
You need to find someone, hopefully local that has the Fanuc eeprom burner in order to program and store the modified ladder.
Al.