We are looking for a list of parameters for a Hitachi Seiki 3NE 300 Lathe with a Fanuc 6T control.
After having a problem with the bubble memory it has since been reset. Unfortunately we are not in receipt of the machines original parameters and subsequently cannot operate the machine until we have reloaded these unique parameters.
We would be grateful if any body has a machine that they could share this information with us.
I can supply you the parameters I use on my 3ne-300. I have upgraded to tulip's buble memory replacement.
I also have electrical schematics and ladder diagrams
message me and all is yours
Hi I also have a question about a hitachi seiki 3ne 300. I have a red led on control panel that stays illuminated after powering up machine. Also the ptcl led on Fuji spindle drive stays illuminated. After everything boots up and hydraulic are turned on it doesn’t go to position screen like it normally would. It stays in a not ready state. If anyone knows what the ptcl led means it would be very helpful for troubleshooting. Any help would be greatly appreciated.