Fanuc 6m + DNC how to ?

[k-linkz]

Hi guys,

need help, need to send the a programm to the fanuc 6m.

it setup as parallel port. to the motherboard.

the program is 01313.NC

power light is ON

Ready is ON

it shows 01313.NC
ready T1

try Fanuc in mode programm and also Edit

O-9999 read

but the program does not transfer.

what are we doing wrong parameter are set as default to parameter

any idea ? or parameter to change.




Similar Threads:

• Fanuc tape cut mate fanuc om paramter setting for cutting materials
• how to shut off Fapt on a 1999 daewoo with FANUC Puma 200 with FANUC 18T control
• Need Help!- Fanuc Robocut Alpha 0B with Fanuc Series 16-W control 910 SRAM Parity System Error
• Weird Rs232 issue/Mystery with Fanuc 6M on Mori Seiki . Calling all Fanuc Masters !
• Need Help!- Fanuc drill tap center equipped with Fanuc OM-C i/o card details

[k-linkz]

Nevermind guys, fix the issue.

issue was a limit switch on the Z axis that was loose. so it was doing it zeros but the connection was bad.

was able to do the transfer all good.

thanks.