LOADING PARAMETERS INTO CONTROL 0-MB

[peloflex]

No it sounds like your parameter write enable is switched off
What control is that

The screen shows a 1 and there is a 100 P/S write enable message.

[peloflex]

I'm wondering if the machine may be in hard overtravel. If so, you must keep the OT bypass and start button pressed while you manually input the 900's. The screen that doesn't have the bottom line is indicating MDI mode.

Hello spark, I was able to find 24vdc at the end of junction between all the OT switches connected in series conn.. and the OT pb connected in parallel. checked good. But still not bad idea to try it. Thank you!
flx

[peloflex]

it says right in the heading: CONTROL 0-MB
PROGRAM PROTECT key is immaterial for parameters.
PWE is 'ON'
He has no sub-cpu
Masterboard has been replaced: no difference

That is exactly correct Sir! Thank you.

[regina]

I believe it is parameter 903 bit 7 =1