How to reset home position on Fanuc robodrill alpha T10A


Results 1 to 5 of 5

Thread: How to reset home position on Fanuc robodrill alpha T10A

  1. #1
    Member
    Join Date
    Feb 2012
    Location
    united states
    Posts
    87
    Downloads
    0
    Uploads
    0

    Default How to reset home position on Fanuc robodrill alpha T10A

    Hi guys, I have found what I think is the procedure to reset the home position as far as the control is concerned, but I cant figure out how to physically locate it on the machine so I can jog there. Supposedly there are some marks or arrows somewhere. Does anyone know where they are? I'm waiting for the maintenance manual.

    Similar Threads:


  2. #2
    Member
    Join Date
    May 2016
    Location
    United Kingdom
    Posts
    324
    Downloads
    0
    Uploads
    0

    Default Re: How to reset home position on Fanuc robodrill alpha T10A

    Hi send me your email address and I will send you the full procedure
    Happy christmas



  3. #3
    Registered
    Join Date
    Mar 2017
    Location
    United States
    Posts
    274
    Downloads
    0
    Uploads
    0

    Default Re: How to reset home position on Fanuc robodrill alpha T10A

    they might just be holes not arrows



  4. #4
    Member
    Join Date
    Feb 2012
    Location
    united states
    Posts
    87
    Downloads
    0
    Uploads
    0

    Default Re: How to reset home position on Fanuc robodrill alpha T10A

    PM sent. Thank you!



  5. #5
    Member
    Join Date
    Feb 2012
    Location
    united states
    Posts
    87
    Downloads
    0
    Uploads
    0

    Default Re: How to reset home position on Fanuc robodrill alpha T10A

    I never was able to get any answers from fanuc or methods on physical dimensions to locate home and there are no arrows or alignment marks. I had to take off all the covers and manually move the screws to just after the dog rode off the homing limit switch and then go into the control and reset the 1815 parameter APZ for each axis. A bad limit switch on the X wasn't helping. It seems to home on the left rear corner of the table which must be correct as now I am able to jog properly and it hits the soft limits just before it would hit the hard limits. What's queer to me though as the numbers it homes to are not 0.00 for the x and y like it is the z. the x is around -10 the the y is around 5. Whatever, seems to work. Still scratching my head. It was changing tools ok for a while but now the turret jammed up mid change, spindle error and now I cant move the turret back to the proper position. The manual says call fanuc in this case



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

How to reset home position on Fanuc robodrill alpha T10A

How to reset home position on Fanuc robodrill alpha T10A