Takisawa TC 2 with Fanuc OT-C

[Almasts]

Need 900 series parameters for a Takisawa TC 2 Fanuc OT-C. I had backed up my parameters before I cleared the memory, Now I find out you need to have manually written down the 900's Does anyone have them or even a picture of your screen with them showing? Thanks in advance.

Similar Threads:

• Takisawa TC-1 Fanuc 0-TC
• Need Help!- Takisawa TC-1 with Fanuc OT
• Need Help!- Takisawa TS-30 parameters for Fanuc 10T
• Need Help!- Takisawa TC-1 FANUC 0TC
• Need Help!- Takisawa/Fanuc 3T

[Almasts]

Wow... 74 views but not 1 reply ??

[zavateandu]

900 parameters are for a cnc like the heart of a human and is hard to find a compatible one,you will have to dig a lot to find same machine type with same controller.

[bill4807]

You may want to look at your spindle parameters too.
On the newer controllers there is a 20 parameter section that you need to write down as well before setting up the spindle type. Because it wipes them..

[Almasts]

Desperation here.... please ?.... https://www.cnczone.com/forums/image...s/drowning.gif almasts.com.au

[matiasjuarez1993]

Hello, did you find them? can you share? my email is matias.juarez93@hotmail.com

[phucrobusl]

Hello, did you find them? can you share? my email is matias.juarez93@hotmail.com

N0900 P 00111000
N0901 P 11101000
N0902 P 00000100
N0903 P 10000000
N0904 P 00000000
N0905 P 00100000
N0906 P 01100000
N0907 P 01011000
N0908 P 00000000
N0909 P 01001011
N0910 P 00000000
N0911 P 00001000
N0912 P 00000000
N0913 P 10000000