After some trials and tribulation I have finally gotten my Fanuc S-5 to power up. With a steep learning curve I was able to figure out how to jog it axes but that pretty much where my knowledge ends. I don't have any machining/G-code experience which likely puts me at a pretty big disadvantage.
Can anyone point me to some material that might help me learn how to program this thing? All help is greatly appreciated
Dont know what you are operating. Is it a mill, router, lathe, probe or robot? In any case, Peter Smid is pretty much the authority on G code and macros. I bought two of his books and after 25 years machining I learned some cool stuff from him.