ER2 alarm on Fanuc controller O-T

[Jd1928]

I can manually move axis but will not home it’s on a Fortune Lathe

Similar Threads:

• Need Help!- ALARM: A14B-0076-B001 01 Fanuc/General Numeric GN22 OTA Controller
• Need Help!- ATC Alarm on Fanuc Controller
• fanuc om controller alarm codes?
• Fanuc 18i controller 926 FSSB alarm

[yoursrakesh]

I can manually move axis but will not home it’s on a Fortune Lathe

Whats the value of Parameter of 1815 APC and APZ

[Jd1928]

Whats the value of Parameter of 1815 APC and APZ

I don’t see 1815? I have seen it on newer controls this goes from 919 to 8100

[Jd1928]

I can’t clear the ER2,alarm on machine side I can jog X andZ manually I cannot move turret or spindle or home it

[zavateandu]

I don’t see 1815? I have seen it on newer controls this goes from 919 to 8100

in your 0T controller ,theAPC and APZ are set in parameter 20 and 21,but in your case,if it is a Victor machine musy be something else,like lubrification or so.
is the single block active?
upload a photo of the operator panel.

[mbservice]

Where is the alarm 2 showing ?
On the drive or the screen ?

[Jd1928]

Where is the alarm 2 showing ?
On the drive or the screen ?

I will send pic later it’s on lower section of main control pannell it has ER1 ER2 and ER3 and just red lights that luninate it has a red ER2 there are no alarms on any boards

[zavateandu]

is this your panel?looks like this?

[Jd1928]

is this your panel?looks like this?

No pic attached

[Hamid35]

I can’t clear the ER2,alarm on machine side I can jog X andZ manually I cannot move turret or spindle or home it

Did u fix it ??
Guys pls help me ???? my cnc lathe is victor vturn 16 and same pproblem

[MarcoGuerrero]

i have same problem, did someone resolve?

[vortech]

I have a similar problem with er2 it doesn't let me move the spindle in mdi, memory and jog, everything else works normally, can you help me?