- Need Help!- Need Help Fanuc Threading Cycle (G76) just first pass. Not run completely
-
Member
Need Help Fanuc Threading Cycle (G76) just first pass. Not run completely
Hello everybody.
I'm trying to run the G76 Threading Cycle in my Turn Fanuc.
System is: Fanuc OI-Mate TB
The G76 command:
G76 P010060 Q100 R0.1
G76 X20.05 Z-9 P975 Q294 F1.5
The machine runs just the FIRST pass and Stop.
The machine does not run the cycle completely.
It's freezes de cycle.
Does anybody know if there is a special parameter [0 ; 0 ; 1 ; 0] to change, if it's blocked?
Similar Threads:
-
- Need Help!- Need Help Fanuc Threading Cycle (G76) just first pass. Not run completely
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules