Not sure if this is the right place to post this, but here goes. I need to get multiple programs on and off a Fanuc 31i control on a Doosan HP6300 Horizontal Mill. I am doing some trial and error work right now and having to load and unload 50+ programs every time I try something different got old before I even started. I know on the 18i controls I would just key in "O-9999" and then read or punch and the control would go from there. On the 31i all I get is a "File not found" error. Is this a simple parameter change to enable the multiple program input/output or did Fanuc actually do away with the option? Thanks in advance!
Just reposted this in the Fanuc forum (didn't realize there was one).