Need Help! Fanuc oiTF manual required


Results 1 to 6 of 6

Thread: Fanuc oiTF manual required

  1. #1
    Registered
    Join Date
    Apr 2018
    Location
    India
    Posts
    11
    Downloads
    0
    Uploads
    0

    Default Fanuc oiTF manual required

    Hello,
    I am new in Fanuc controller. Can any body help me to identify the G & F code meaning i.e. commands/information from CNC to PMC via F code & from PMC to CNC via G code.
    Manuals or link help will be much appreciated.
    Thanks in advance.

    Similar Threads:


  2. #2
    Registered
    Join Date
    Apr 2018
    Location
    India
    Posts
    11
    Downloads
    0
    Uploads
    0

    Default Re: Fanuc oiTF manual required

    In PMC ladder, F0007.3, F0026.2, F0094.1, G0043.7, G0070.7, G0027.0, G0043.5 etc. etc. codes are used. I want to know the meaning or information of these bits. How to find out?
    Can any body help.
    Thanks in advance.



  3. #3
    Registered
    Join Date
    Apr 2011
    Location
    USA
    Posts
    419
    Downloads
    0
    Uploads
    0

    Default Re: Fanuc oiTF manual required

    You are going to need Fanuc manual B-64603EN-1. This explains what they all do.



  4. #4
    Registered
    Join Date
    Apr 2018
    Location
    India
    Posts
    11
    Downloads
    0
    Uploads
    0

    Default Re: Fanuc oiTF manual required

    Hello,
    Thank you very much for interest shown & reply.
    Manual which you mentioned is hardware manual & expalins different types of hardwares & their methods to configure I/O address.
    I want to understand the data transfer/communicated between CNC & PMC via F & G addresses.
    Kindly help.
    Regards



  5. #5
    Registered
    Join Date
    Apr 2011
    Location
    USA
    Posts
    419
    Downloads
    0
    Uploads
    0

    Default Re: Fanuc oiTF manual required

    Basically the G address are the "Commands" from the PMC to the CNC the F addresses are the confirmation that it happened. G7.2 is cycle start, IF the CNC is in the ready state, no lalrms in Auto mode and has a program ready to run. When you press the cycle start button the logic has a rung with G7.2 This will go on stating "Start the Cycle, an F bit goes on stating that the cycle is running F0.5
    Hope this helps



  6. #6
    Registered
    Join Date
    Apr 2011
    Location
    USA
    Posts
    419
    Downloads
    0
    Uploads
    0

    Default Re: Fanuc oiTF manual required

    This manual explains in detail what each G address and F addresss does. (B-64603EN-1)



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Fanuc oiTF manual required

Fanuc oiTF manual required