Fanuc 0m Program creating not possible

[bact]

Hi, i have a Takiswa MAC V1E with Fanuc 0mb and lost Parameters. My problem is i have no documentation.
I can start it up with some parameters i have found in the internet without errors. But i am not able to enter a program.
I switch to edit mode but when i hit the program softkey i get no cursor to enter O0001.
Maybe someone can help me with the parameters.

Thanks

Similar Threads:

• Program recomendations for fanuc drip feed/program input/output
• Need Help!- Creating a data monitor for Fanuc Wire EDM's
• I could use an assit creating variable program
• Creating Sub Program In Genises
• help creating program

[memoryman]

Your control may need the options reinstalled (900 series parameters).
Also, if the control uses the built in PMC, the 'diagnostics' (PMC parameters) need to be entered.