Originally Posted by
Oviksnc
Hi,
I have a small problem with my old Mazak ST-15 Fanuc 6T-B i think ( over 160 parameters ). I have a laptop with a USB-RS232 adapter using PCComm for file transfer. The rs232 cable came with the machine and was working fine according to the previous owner.
However, if i set tape edit and tranfer let´s say O0100 the controller shows O0100 in the top of the screen then freezes. It will not respond to anything except emergency stop, if i release the E-stop again i get the not ready alarm. The only way to get out is to restart the system. Then i can open and run the O0100 program without any issues.
Do someone know anything that can point me in the right direction here? And if i could have all the correct parameter settings for my controller it would be great. The 311 parameter was set to 00001001 when i bought it, i have tried other setups as well ( reading this forum and others ) but i only get alarm 085 or 087 or a controller freeze.
Thanks