parameter 9102#4 - radius comp. B
9102#5 - radius comp. C
see how to change this parameter in attached file
Hi everyone.
I have a question, about tool radius o. Offset page, in 10m control.
When i go to the offset page, i can only entrer tool length, but no tool radius. In the Manual, an offset page is show with both length and radius, and the corosponding wear.
How can i 'activate' this?
IT should be said, that this machine is recovering from a total parameter clear. It was in storage for 2 years, and the battery died. I tried to get a parameter list, from MTB, but since the machine is from 1986,those parameters were lost. But I am able to run it now, after several weeks of trial and errors. Long story short, it may very well be a parameter/option, that need to be changed.
The machine is a Dah-lih mcv 1200.
THE pictures attached shows our current starte of the tool offset page, and the picture from the Manual, that I want to se on the machine.
I hope someone can point me in the right direction.
Thanks in advance.
Axl
Similar Threads:
parameter 9102#4 - radius comp. B
9102#5 - radius comp. C
see how to change this parameter in attached file
what was the string of 1s 0s that you had to enter in 9102 to enable the radius wear offset?
Last edited by Lionelconnell; 07-14-2018 at 02:11 AM.