skip command

[sailikhith3546]

I am working on reverse engineering a touch probe and integrating it into the machine. I need to know what does skip mean and how is it used( not skip command in code '/')

Similar Threads:

• Move command works until velocity command issued
• Need Help!- How to skip a tool
• Skip Signal
• New skip in the house

[Mike283]

In Fanuc controls the skip command is usually a G31, it’s non-modal. When one or more axes are moving in G31 move the axes will stop immediately when a skip signal is input to the control from the probe or other device. Once the motion stops the program proceeds to the next line in the program.

Hope this helps.

[underthetire]

And, make sure you use the controls 24vdc power, not a machine side. They are typically normally closed and open when triggered.

Sent from my SM-T813 using Tapatalk