RAM won't start up?

[Gjestrud]

I have some problems with my Dainichi B35 lathe:
I was making some parts and suddenly it stoppet in the middle of the cut and the monitor was frozen on the same screen.
Tried to reset but nothing happened.
When i try to restart the machine i get the following:

FS10TF 1315K
ROM: end
RAM:

Nothing happens after this and i get no alarm message on the screen.
Only thing i can see is a red light on the RAM.

I read that others had a problem with the "RAM parity error", could this be the same?
I would really appriciate some help with this



Similar Threads:

• Start from line - error: Radius difference too large between start and end of arc
• 1 start or 2 start anti-backlash nuts?
• Arrow 750 Failed to start when I Push start Bottom in fornt of control !
• Single start vs double start ballscrew.

[Gjestrud]

Bump

[shibub]

have you solved this issue ?