The toolchange macro came from YCI... no need to contact Fanuc for this.
Here's a listing of the macro from an XV. It's in the Operator's Manual if you have one.
Hello all,
I hope someone can help me with this problem?
First - I had an 101 PS alarm and was able to clear this alarm
101 PS = while writing to part program the power was turned off (didn't happen but this alarm just showed up)
Second - I then recieved a 078 PS alarm
078 PS alarm = A program number or a sequence number which was specified by address P in the block whcih includes an M98, M99, G65 or G66 was not found
1- I just noticed that all my part programs have been deleted
2- I reloaded the part program in the machine
3- I then recieved the 078 PS alarm still
4- went to MDI and called up a manual tool change M6T# and then recieved the same alarm
5- I am assuming that the tool change macros where probably lost as well?
6- I do not have any back ups of the macros
7- does anyone know what could cause this? The 09000 programs are hidden, I have been reading on how to turn off the write protect.
8- If the O9000 programs are lost - does anyone have a copy of this or do I have to call fanuc?
9- I would really appreciate it someone could help me with this.
10- are there any other macros that I need (more than 1 O9000 programs)
YCI Supermax Rebel 1
20 tool changer umbrella style
Fanuc om control
just a basic 3 axis machine
I'll appreciate any help
Thanks
Similar Threads:
The toolchange macro came from YCI... no need to contact Fanuc for this.
Here's a listing of the macro from an XV. It's in the Operator's Manual if you have one.
Gus,
Looks like you found it. I posted over in the help forum in your other thread as well.
Stevo
I have a supermax rebel1 ycm-60A 16 tool umbrella style but it has a meldas M3 control. I have been unabke yo get the tool change macro from ycm. They sent me one for a 65A with meldas m6 control. Does anybody have the 9000 macros for a YCM 60A with a mitsubishi melsas M3 control. I need the tool change macro
Thank you very much for the information, can you please share the manual, I have the same problem and I do not have someone at my disposal to do this procedure, and I would like to have more information.
I'm looking for an operator and electrical manual for a Rebel 1 with Fanuc 0-M control. Does anyone have them to share? I'll happily pay for it!