Hi All

Can someone help please?

The lathe had a problem with the chuck drive motor, which was removed for repair. Whilst the motor was removed the power to the machine was turned off and yes you have guessed it, when the lathe was powered up the backup battery had gone flat and all the parameters were lost.

We have managed to get a copy of the parameters and loaded them into the machine but we now have the following error codes flashing up on the spindle drive.

The Drive is a SPD 1.35-S0-0

The error codes are E505 E605 E805 these just flash one after the other, I have looked everywhere for the info, but I have drawn a blank so far. Any help would be very much appreciated.

Andy

Similar Threads: