- Help needed to transfer gcode files from Pc to 8055tc
-
Member
Help needed to transfer gcode files from Pc to 8055tc
Hi All,
After some advise on how to send files from pc to Fagor 8055 tc Lathe controller.(older version earlier 2000 model)
Cant see anything in the manuals , but i see a serial port on the side so I'm assuming i can.
here is a screen shot of the front panel
Any ideas ???
Thanks
Similar Threads:
-
-
Member
Re: Help needed to transfer gcode files from Pc to 8055tc
...this may help you. I see a link for the cable wiring and some free software here>https://atrump.com/images/tech_suppo...munication.pdf
There is also Putty you can use to download. > https://www.putty.org/
Good luck hunting,
DJ
-
Member
Re: Help needed to transfer gcode files from Pc to 8055tc
Thanks for that will check it out
-
Member
Re: Help needed to transfer gcode files from Pc to 8055tc
Had a look , i cant get to the screen that says load. Not working for me.
Ive checked manuals and cant see anything
Surely there's a way to send a gcode file to the machine.
-
Member
Re: Help needed to transfer gcode files from Pc to 8055tc
further to my last .........................Shift key then ESC works , happy days
i was holding both keys down together
- Help needed to transfer gcode files from Pc to 8055tc
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules