Gday Everyone

I have a fagor 800mg that I have had for a few months. Just after I managed to set it up. I could write a program on the controller and execute it. I finally managed to get it to connect up to the computer and I transferred a program onto it. Since then it will load a program i can tell it to start and it comes up with error 14 (a block has been programmed which is incorrect either by its self or in relation with the program history up to that instant).
So I deleted that program. I then tried to set up another program on the controller again but I am still getting error 14. It starts, asks me to change tool and then error 14.
Does anyone know what this may be.

Similar Threads: