Do you have a soft limit set on the Z axis?
I am running an 8055i control on a Cincinnati mill. I can run the conversational part somewhat well but I am having an issue running a program I run off of Fusion 360. I get the program loaded into the hard disk ok. But I keep getting a Z axis overtravel alarm. I set the Z the same way I did on the conversational side (touch tool to top of part and hit Z Enter in tool calibration).. is this not right?
Do you have a soft limit set on the Z axis?
[FONT=Verdana]Andrew Werby[/FONT]
[URL="http://www.computersculpture.com/"]Website[/URL]
Please send me a message with your program generated by fusion or post it on here