- Need Help!- X axis losing 0.01
-
*Registered User*
X axis losing 0.01
Hi,
i recently started to fix an old fagor 8025 MSI for my shop.
I did read alot in the installation manual for settings and parameters.
i made it run and made some program for it and she takes it all, very happy.
But then i tried to make a bored hole.. 0.01 ovality... #oh****
I tried to check if i had backlash in X : not even a 0.001
Then, tried to make just a slot ( 2 inch long, 1/4 depth and 3/8 wide) ; i lost 0.005 on both ends.
Mechanic look great and i can`t find any parameter to help my case.
so help me you guys please.
leo
Similar Threads:
-
- Need Help!- X axis losing 0.01
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules