Fagor 800T

[blakey235]

Does anyone out there know what causes error 34: Strange Character, Fagor Automation give me wishy washy reasons,
sent them program they say its OK. must be a better set of reasons for cause of the error

Similar Threads:

• Fagor 800t Error 064
• Need Help!- FAGOR 800T
• Fagor 800T
• Fagor 800T

[CNCTech25]

Does anyone out there know what causes error 34: Strange Character, Fagor Automation give me wishy washy reasons,
sent them program they say its OK. must be a better set of reasons for cause of the error

My manual says "S or F value too large" for error 34

[FAMATechnology]

The Error "Strange Character" suppose to be Error Number 105.

Could you please provide more information? How do you write your program? Through G-Code or conversational?

[blakey235]

The Error "Strange Character" suppose to be Error Number 105.

Could you please provide more information? How do you write your program? Through G-Code or conversational?

Error 34 I have discovered is caused by an extra control character at the end of the file listing, move cursor to the end and backspace over it, save and re-send 99996 lovely message SENT instead of strange character

[blakey235]

Error 34 I have discovered is caused by an extra control character at the end of the file listing, move cursor to the end and backspace over it, save and re-send 99996 lovely message SENT instead of strange character

Thanks for your reply, correct answer wasted loads of time sorting that out! you would think Fagor UK would have known
that