TRY 7-10
I had posted previously on this.
The jumper socket is supposed to have 12-5 jumped along with another (I don't have a manual in front of me). I've been trying to get the 4th working (finally did) but I'm not sure about the jumper. I re-installed the 12-5. It had been cut somewhere in it's life, before me. The axis rotated +A CW, I clipped the jumper again. No change. I swapped the motor leads at the amp, (it didn't like that). What else can I do to change the direction of rotation?
Thanks,
Tim
Similar Threads:
TRY 7-10
Is this how and where you have it mounted?
www.integratedmechanical.ca
The jumper at J4 of pins 5 to 12 is for the direction of the motor along with the proper connection combination of the motor and tach wires.
Neal
I do have the axis mounted as shown in the picture.
I did try swapping the motor leads (at the amp) so I will try swapping the tach leads.
Thanks,
Tim
What would the jumpers be set to if the chuck face was horizontal (can it be?) instead of vertical on a VH65? Say the motor is positioned in the same direction as the pic, above.