Hi,
Our Fadal has a Fanuc Oi-MC control. The physical location of the drum is 3 spaces from where the control thinks it is. That is, I set drum 4 with tool 6 and when I call up T6, the drum will go pull from drum 1. The control will then display drum 4 as the current position. Could someone help me reset my carousel position relative to the control? I am fairly new this so any help would be appreciated.
Thank You,
Andy
Similar Threads:
...Fanuc not sure--- but we learn fast.
Last edited by machinehop5; 01-20-2023 at 09:09 PM.
...we all three learning something. I found TC reset in a Fadal manual for Fanuc control Chapter 7.3
https://flintmachine.com/images/uplo...tor_Manual.pdf
Also, the Siemens control Restore Magazine Count page 107
https://flintmachine.com/images/uplo...nce_Manual.pdf