Pozi Pulley spacing - Motor Side

[rwskinner]

Does anyone know what the spacing should be on the Pozi "motor" pulley?

ITS says to use the SVT-0130 which is 1.760" tall for the spindle pulley but That's way more than what the motor pulley is. It's closer to around 0.750 or so by glancing.

Can I put it back where it is now, yes, but I'm not sure it's correct since it had the motor replaced in the past, and the belt life sucks from misalignment.
I'm replacing the spindle, a bad motor pulley, and belts while I'm in there and just want to space it correctly.

Thanks.
Richard

Similar Threads:

• VMC15 XT motor pulley and spindle pulley
• Fadal 4020 pozi belt
• Need specs for a spincle motor on a 1994 Haas VFO and how is the motor pulley removed
• DC Gear motor and power off brake(on the load side not on motor)
• Motor pulley

[rwskinner]

Way smoother and quieter!